Pentair IntelliCenter— RTI XP Driver
Adds pumps, chemistry, salt, and schedules to your IntelliCenter.
About this driver
Two-way RTI control of a Pentair IntelliCenter pool and spa controller over your LAN. A community driver by aviet on the RTI Forums has been the go-to since 2023 and handles the basics well — bodies, circuits, lights with color presets. This driver focuses on the equipment that one doesn't expose: pump telemetry (live watts, RPM, GPM), IntelliChem (pH, ORP, tank levels, alarms), IntelliChlor (salt level, primary/secondary %, super-chlorinate), schedule status, water + solar temperature sensors, vacation mode, and heater selection by name. Auto-binds to the RTI Climate template so dropping a Pool Body source into a room populates Heat/Off/setpoint buttons with no macro work. Local push updates — no cloud, no Pentair Home account.
What's included
- Live pump telemetry — watts, RPM, GPM per variable-speed pump
- IntelliChem: pH, ORP, pH/ORP tank levels, high/low alarms
- IntelliChlor: salt level, primary/secondary output %, super-chlorinate
- Schedule status visibility for up to 20 schedules
- Water + solar temperature sensors (in addition to air)
- Heater selection by name (Gas / Heat Pump / Solar) per body
- RTI Climate template auto-binds — Heat/Off/setpoint buttons populate themselves
- Zero-config setup — equipment auto-discovers; no per-circuit name typing
- Vacation mode + service mode visibility
- Local LAN only — no cloud, no Pentair Home account
How the beta works
- Download the driver (free — button on the right), install it in Integration Designer, and load it to your processor. It runs unlocked for 120 minutes per session.
- Run it on your real hardware and put it through its paces — the beta exists to cover the checks we can't do without the physical device.
- Email [email protected] with how it went — a bug, a rough edge, or just "it works." Report an issue and we'll give you the finished driver free on one processor.